Photos of the Model DX-EE/DX-CC type parallel dipoles Price List

Limited Space High Performance Antennas

Unlike the usual trap antenna, there are no capacitors to break down under high RF voltages. 50 Ohm direct coax feed; tuner usually not required when operating in resonant bands, but may be used for multi-band.

DX-CC Antenna

Model DX-CC multi-band 80, 40, 20, 15 and 10 meter dipole








DX-A - 160-80-40 Meter 1/4-wave Twin Sloper - A top low frequency DX antenna. Combines the tremendous DX firepower of the 1/4-wave sloper with the wide bandwidth of the 1/2-wave dipole. One leg is 67 ft., the other 55 ft. Installs like an Inverted-V with ground return accomplished thru tower or down-lead.

DX-B - 1/4-wave DX sloper - A single wire with high performance on 160, 80, 40 & 30 meters. Designed for limited space installations where room doesn't allow for the DX-A twin sloper. Requires only 60 ft. overall and provides amazing DX performance at installation heights of only 35 ft., and with the low end at only 8 ft. Pre-assembled & Pre-tuned. – just put it up and start enjoying low band operation. Utilizes stainless-steel hardware, 12 gauge solid copper wire and efficient Alpha Delta "Iso-Res" RF choke coils. To gain the same broadbanded performance like the DX-A, the DX-B is also designed to be used with a wide range antenna tuner, so no trimming or tweaking is necessary. 50 Ohm coax feed, rated for full legal power.

The Models DX-A and DX-B quarter wave slopers require mounting on a grounded tower with an HF size beam on top to act as a "capacity hat". This is necessary for proper tuning and operation. This is not a requirement for half wave dipoles, but unique to quarter wave slopers for transmitting.

Instructions For Models DX-A and DX-B

DX-SWL - SWL Broadcast Sloper - Covers the 13, 16, 19, 21, 25, 31, 41, 49, 60, 90, and 120M short-wave bands plus the AM broadcast band. Sloper design provides outstanding reception of low-angle DX signals. Multi-band 2KW transmit capability with an appropriate antenna tuner. Overall length is 60 ft.

Installation Instructions


DX-CC - “No-Trap” 80-40-20-15-10 meter dipole or inverted-V. Overall length is 82 ft.

DX-DD - “No-Trap” 80 and 40 meter dipole or inverted-V. Overall length is 82 ft.

DX-EE - “No-Trap” 40-20-15-10 meter dipole or inverted V. Also covers 30-17 & 12 meters with an antenna tuner. Overall length is 40 ft.

Low Band Dipole Covers 160-80-40 meters with an overall length of only 100 ft. Antenna performance and 2:1 VSWR bandwidth is site dependent and varies with height above ground and surrounding objects. The typical bandwidth is:

160M – 20kHz • 80M – 40 kHz • 40M – 300 kHz

Full band coverage can be accomplished with an antenna tuner. Built with insulated 12ga. wire, stainless steel hardware and uses the Model DELTA-C static protected center insulator and CIN end insulators. Use coax or open wire line and configure as a dipole or inverted-V. Assembled and ready to go!

Model DX-LB PLUS, same as Model DX-LB but adds parallel wires for operation on 20 thru 10 meters.

Directions For Models DX-CC, DD, EE, LB and Plus

 DX-ULTRA - Design and construction same as the Model DX-CC, but slightly retuned to favor HF shortwave.

This Shortwave Dipole Antenna Covers AM Broadcast through 30MHz. Provides efficient, low-noise, broadband performance for Medium Wave, Tropical, International SW, Military, Government, Embassy, Maritime, Aircraft, Commercial and Utility frequencies. ISO-RES inductors, parallel wire elements and the exclusive DELTA-C Center Insulator with the built-in ARC-PLUG® Static Electricity Protector. Over all length is 80 ft.; may be installed as a dipole, inverted-vee, or full sloper. It can be used with an antenna tuner as a transmit antenna up to 30 MHz. Connectors will accept either coaxial cable or balanced line. Fully assembled, ready to go!

Installation instructions for Model DX-ULTRA

DX-Series - Monoband Dipoles

Full-size dipoles utilizing the Delta-C Center Insulator with built-in Arc-Plug® Surge Suppressor. Fully assembled using 12 ga. insulated high-strength solid copper wire, CIN end insulators & 50 ft. nylon support rope. Feed with coaxial cable or open-line, rated for legal power.

Directions For Models DX-80, DX-40 and DX-20 Monoband Antennas